2. The glue is to recover all the glue in the position of the entire target piece. In order to reduce the volume of the glue, it can be done with a relatively thin glue, as long as it is enough to be spotted, a thin and wide comb can also be used to run the glue.
3. Regarding the protection, it is enough after the general plexiglass, put on a protective mask to protect the eyes, if you wear resin glasses. If you are very afraid of UV radiation, or have special requirements for glue, such as the requirement for EB-free, you can use a dot marker and a graduated ruler to take a photo to determine the position of the target strip on the glue.
4. Follow the normal procedure to mark the glue, then cut the glue with the marker, EB stain, and take photos with the graduated ruler under the UV lamp. Since the relative position between the belt to be recovered and the marker is known, the position of the target belt on the undyed glue can be measured by the ruler. If you find it difficult to judge, you can point a small amount directly on the marker, so the position is easy to determine.
Use and precautions for gel imaging analysis systems:
• Pay attention to the boot sequence, first open the gel imaging system, then turn on the computer to enter the software.
• To prevent EB contamination of the instrument during UV gel photography, the door of the gel imaging system should not be in contact with contaminated gloves and should not be exposed to contaminated gloves during software operation.
• The front panel of the gel imaging system cannot be opened during photography with an ultraviolet light source.
• Remove the waste material after taking the picture and wipe it off with a soft paper.
• Be light when focusing, and do not be drastic.
Volsen owns a professional custom synthesis department, with more than 15 senior scientific research chemical personnels who have a graduate degree or above. We also have an independent scientific management system. Our company integrates years of production experiences and talent reserves that forms a strong R&D production capacity, furthermore we could undertake various chemicals customizations from kg to ton relying on the existing production base and equipment.
With the accumulated strong expertise,and experiences of developments,we have developed the products with good quality and also manufactured the intermediates for multi-national Pharmaceutical company.
R&D Pharmaceutical, Research And Development Pharmaceutical, Bulk Drug Development
Taizhou Volsen Chemical Co., Ltd. , https://www.volsenchem.com