In addition to scale. Put the two old peeled, seeded old loofahs in a clean water tank and replace them regularly.
The piston ring is not elastic enough. A standard new ring of the same type can be used, with the old ring being examined being placed vertically along the circumference and with both ring openings in a horizontal position. Then press the two rings by hand. If the opening of the new ring does not move, the opening of the old ring has been closed, indicating that the old ring is flexible and can continue to be used.
Repair of a broken paper mat. Apply a little butter on both sides of the paper pad, and then cut two thin white papers of the same size as the paper pad, affix them to both sides of the paper pad, and place them on the machine. Tighten the nuts to eliminate leakage.
Drain the air in the pump. If the air in the pump is not drained, there will be failure to pump oil. At this time, a medical waste cannula can be used to fill up the oil, and the pump inlet port can be filled with oil, and the oil pump can be turned to discharge the oil.
The oil leakage is caused by the connection between the nose of the high pressure oil pipe and the injector and the oil valve. A round copper skin can be cut from the waste cylinder pad, with a small hole in the middle, and it can be placed between the boss and the pit.
Iron filter remover. The iron filter of the air filter is difficult to wash with diesel oil. If the filter element is stained with diesel oil, it can be ignited and burned. After the fire is extinguished, the filter element is knocked with a wooden stick to make the smoke fall off and the dirt inside and outside the filter element can be completely removed. Things.
In addition to dirt inside the fine filter. The dirt and dirt in the rotor oil filter cannot be easily removed. If a layer of paper is applied to the inner wall of the rotor with butter, and the soil is attached to the paper, the paper can be removed and the soil can be completely removed.
Bend tubing. The copper tubing is made of hard material, so it is not easy to bend and install. You can use the charcoal to burn red in the area you want to bend, and immediately put it in water to cool it, and it will become soft and easy to bend.
Remove the deceleration gear outside the strong retaining ring. The Dongfeng-12 hand drags the outer elastic retaining ring of the reduction gear in the transmission, and it is very difficult to disassemble it. At this time with a wire, one end through the small hole in the ring after the tightening, the other end with a screwdriver wound, tightly pull, and then rotate the drive wheel back and forth a few times, the ring can be removed.
Dietary Supplement and Food additives
Dietary Supplement,Pyrroloquinoline Quinone,Pqq Acid,Pqq Pyrroloquinoline Quinone
Fuzhou Contay Biotechnology Co., Ltd , https://www.contaybio.com