Automatic labeling machine price common fault correct maintenance

With the continuous expansion of the price range of automatic labeling machines, the automatic labeling machine has also played an important role. We all hope that the price of the automatic labeling machine used by ourselves will have high quality and long life. If we have properly handled the common faults, our automatic labeling machine will naturally extend the product's service life for a long time. Therefore, in the process of using the automatic labeling machine, the common faults are properly repaired. important.

First, try to avoid or eliminate the impact of the price of automatic labeling machine on the labeling static electricity. It is easy to generate static electricity during the labeling process, which will have more or less influence on the labeling effect. If the humidity of the labeling site is improved at an appropriate time, there will be some improvement. It is also a very effective solution to use the ion fan. The internality of the labeling machine is automatically controlled by humidity, and the internal cleanliness of the equipment can be separately controlled to keep the label away from dust and improve the labeling quality of the product. In this way, there will be no more warning phenomenon in the process of labeling, and the price of the automatic labeling machine will also achieve a visual effect.

Second, increase the viscosity of the price label of the automatic labeling machine, try to make the label stick firmly. To achieve this effect, it must be considered to improve the surface quality of the hose being attached. Most of the products have a lot of varnish on the surface, which will increase the difficulty of labeling, easy to make the contents ooze out, the micropores in the tube wall, etc. will cause the label to rise, we should consider the more important next. The problem is how to avoid or reduce the occurrence of such problems; control the labeling pressure of the label during the automatic labeling machine price labeling process; control the temperature during the labeling process. Increasing the temperature of the labeling will not only improve the effect of the price labeling of the automatic labeling machine, but as the temperature increases, the activity of the internal material of the object will correspondingly increase, and the label will be more easily integrated with the tube body.

Third, the automatic labeling machine price of the scraping rubber sheet and the rubber roller can not appear gaps in the entire length, if there is a gap, you can adjust the gap of the scraping rubber board by adjusting the eccentric bolt. The label and the rubber roller are only in contact with each other without any pressure. If the gap is too large and there is too much glue on the target board, it will cause silicone. If the gap is too small, the contact between the target and the rubber roller is too tight, the glue will be squeezed away, and there is no glue on the half of the target. After a lot of experiments, it is proved that the gap between the target plate and the rubber roller is between 0.1mm and 0.2mm. The gap can be made larger or smaller by adjusting the bearing housing at the lower part of the rubber roller. If necessary, the bearing on the upper part of the rubber roller should be adjusted.