1. After you buy a new machine, before you use the engine, you must first carefully read the operating instructions of the machine. You should pay special attention to the basic requirements of the book:
(1) Use fuel of the specified grade, fully precipitate and filter before use, and the oiler should be kept clean.
(2) The lubricating oil should be kept clean, and the amount added must be sufficient, and it should be replaced regularly. The use of the grade should be consistent with the regulations.
(3) The air cleaner should always pay attention to maintenance.
(4) Care should be taken to add cooling water, especially if the engine is not to be operated in a water shortage.
(5) Always pay attention to check and tighten the relevant bolts and nuts, especially the connecting rod bolts, the bolts on the drive shaft and the lock nuts on the flywheel, and the fastening nuts on the wheels.
If the user buys a new camera and really does it in accordance with the above basic requirements, then the life of the camera can be greatly extended.
2. After you buy a new machine, do not carry the load immediately. You should run it in accordance with the instructions. After the running-in is completed, the machine oil filter is cleaned and residual impurities in the engine oil are removed. If necessary, the engine oil must be replaced and the oil pan cleaned.
3. When the new machine operates, it must be done strictly in accordance with the requirements of the manufacturer's instructions. No overloading, no speeding, no overfeeding, no long-term overloading.
4, can not be free to modify the new machine and any increase engine speed. In order to make the machine run faster, some users may arbitrarily adjust the fuel supply and pressure of the high-pressure oil pump, and some of them tie the governor spring wire. This is even more wrong.
(1) Use fuel of the specified grade, fully precipitate and filter before use, and the oiler should be kept clean.
(2) The lubricating oil should be kept clean, and the amount added must be sufficient, and it should be replaced regularly. The use of the grade should be consistent with the regulations.
(3) The air cleaner should always pay attention to maintenance.
(4) Care should be taken to add cooling water, especially if the engine is not to be operated in a water shortage.
(5) Always pay attention to check and tighten the relevant bolts and nuts, especially the connecting rod bolts, the bolts on the drive shaft and the lock nuts on the flywheel, and the fastening nuts on the wheels.
If the user buys a new camera and really does it in accordance with the above basic requirements, then the life of the camera can be greatly extended.
2. After you buy a new machine, do not carry the load immediately. You should run it in accordance with the instructions. After the running-in is completed, the machine oil filter is cleaned and residual impurities in the engine oil are removed. If necessary, the engine oil must be replaced and the oil pan cleaned.
3. When the new machine operates, it must be done strictly in accordance with the requirements of the manufacturer's instructions. No overloading, no speeding, no overfeeding, no long-term overloading.
4, can not be free to modify the new machine and any increase engine speed. In order to make the machine run faster, some users may arbitrarily adjust the fuel supply and pressure of the high-pressure oil pump, and some of them tie the governor spring wire. This is even more wrong.
Wetting Agent,Wetting Penetrating Agent,Wetting Adjuvant,Agricultural Wetting Agent
Jiangxi Tiansheng New Materials Co.,Ltd , http://www.jxtsxcl.com